CWNP CWDP Wi-Fi Design CWDP-304

短時間で十分の試験準備

CWNP　CWDP-304試験に備え始める方法を知らないのなら、Japancert.comはあなたの勉強ガイドです。優れたPDF＆SOFT試験資材は、試験に必要なすべての重要なポイントをカバーしています。あなたはただそれを学ぶために20〜30時間がかかります。

1年無料更新と返金保証

Japancert.comは一年間無料更新サービスをお客様に提供します。 いったん試験素材が更新したら、我々はすぐに試験質問と回答を更新して、自動的に最新のバージョン をあなたのメールボックスに送ります。あなたが試験に失敗した場合は、ただメールの添付ファイルでスキャンされた不合格の証明書を弊社のメールボックスに送ることが必要です。確認後、全額で返金します。

購入前に無料デモの提供

あなたがJapancert.comを選択する前に、CWNP　CWDP-304試験についての質問と回答の一部を含む私たちの無料デモをダウンロードすることができます。我々のCWNP　CWDP-304試験トレーニング資料の助けを借りて、あなたは簡単に試験に合格します。 Japancert.comは、あなたの最高の選択です。

CWDP-304試験問題集をすぐにダウンロード：成功に支払ってから、我々のシステムは自動的にメールであなたの購入した商品をあなたのメールアドレスにお送りいたします。（12時間以内で届かないなら、我々を連絡してください。Note：ゴミ箱の検査を忘れないでください。）

現在、CWNP　CWDP-304認定試験は、多くの人が楽しんで、それはあなたの能力を測定することができます。CWNP認定試験の証明書で、良い仕事、より良い未来を持っています。

CWNP　CWDP-304試験にパスすることは、これまでより速くなかったか、より簡単でありませんでした。 今Japancert.com CWDP-304の質問と回答で、あなたは絶対に最初の試行で試験に合格することができます。

Japancert.comは、高品質と優れた価値の認定試験の材料を提供する良いウェブサイトです。我々の試験模擬問題集は専門家によって書かれています。彼らは、本当の試験の基礎において、最高と最新の質問と回答を候補者に提供することに専念します。ヒット率の99.9％は絶対にあなたがCWDP-304試験に合格するのを助けることができます。

CWNP CWDP-304 試験シラバストピック:

CWNP Certified Wireless Design Professional 認定 CWDP-304 試験問題：

1. The thermal noise is at #174 dBm/Hz. A spectrum analyzer has a resolution bandwidth of 1 kHz and a 5 dB noise figure. What is the level of the noise floor?
Response:

A) #174 dBm
B) #144 dBm
C) #204 dBm
D) #139 dBm

2. While configuring your site survey software for an upcoming manual survey project, you notice the configuration option for "Network Card Simulation". What is the purpose of such a feature and when would you use it?

A) Since WLAN adapters are not typically calibrated by manufacturers, this setting is a form of software calibration in which you can calibrate an (uncalibrated) adapter to match one of the calibrated adapters shown in the list. This process improves the reliability of RF data collection and reporting when uncalibrated adapters are used.
B) This setting allows the site survey software to convert the APs measured downlink RF data into a simulated data set as if the same data were transmitted by a specific client station. It is useful for determining uplink client performance when clients are located far from APs as well as projecting cell size for ad hoc networks.
C) This is the configuration area in which you specify the adapter type that will be used for the site survey so that the survey software can interpret that adapters reported metrics (based on proprietary formulas) into an RF measurement that is standardized by the survey software and known to its users. This is done

3. During lunch time in the break room of a company, Wi-Fi connectivity on the 2.4 GHz band is intermittent.
Every other time of the day, it works fine.
What's the likely cause of this issue?

A) Microwaves in the cafeteria are interfering with the Wi-Fi on the 2.4 GHz band
B) The AP in the cafeteria keeps rebooting due to lack of PoE budget on the switch
C) Toasters and ovens are heating up the air, raising the noise floor with the Wi-Fi on the 2.4 Ghz band
D) Employees are using their cell data instead of using the Wi-Fi

4. You are on site, planning a network at a freight shipping company on a busy harbor. Since the preliminary WLAN design specifies support for the 5 GHz spectrum, you would like to test for radar pulses to determine if DFS channels should be supported at this facility. As a part of your spectral survey with a laptop-based analyzer, you include DFS testing to identify the presence of radar. This is done by manually observing Real-time FFT, Duty Cycle, and Active Devices charts of the spectrum analyzer software.
What potential drawback is present with this DFS test method?

A) Many WLAN products that support DFS channels report several false positives. Ideally, the actual WLAN equipment used in the deployment should be used to test for DFS.
B) Modern spectrum analyzer adapters do not provide the necessary bandwidth resolution required to detect and measure radar signatures.
C) Manual identification of radar pulses using spectrum analysis charts can be very difficult due to radar's low amplitude at the Wi-Fi receiver.
D) Some sources of 5 GHz radar, such as military ships, are mobile in nature. A longer, automated test setup should be used to identify the presence or absence of radar.

5. For what types of systems should you request read-only access to in order to perform an analysis of the customer's existing infrastructure?(Choose all that apply.) Response:

A) Switches
B) Clients
C) RADIUS
D) Active Directory
E) Routers

質問と回答：